BookTitleOkabe Product Catalog

Summary

Okabe Product Catalog

Sealing Cone ＋ Tube BondAdhesive-applied mortarcone for sealing tie holesSealing Cone：All-In-OneAdhesive-integrated mortar cone forsealing tie holesFeatures● All-In-One sealing cone (cone & adhesive)● Maintains an appearance of concretesurface.● No martar-mixing, plasterwork, and skillsrequired.● Special adhesive enables long-lastingprotection against wind and rain● If the surface is wet, do not use the product, but instead,apply Mortar Cone and Mortar Cone Bond. (P39)● Avoid excessive tightening of form tie which causedeformation of plastic cones and holes.● Be sure to remove and clean aggregates left in theholes.● Do not use the product when water leakage isfound.● Be sure to cure after the installation.● Check adhesive hardening before surface-plasterwork.● Minimum usable temperature : 5℃● After opening the package, use the product as soonas possible.CautionsProduct Quantity(pc/case)Weight(kg/case) PackingFLAT 100×5 13 CaseDENT 100×5 12 CaseSeling coneAdhesive capsuleSeparatorHole left byPlastic Cone1. Push the cone till separatorbreaks the capsule(Make sure not to push the conetill the end at this moment)Adhesive bond2. Rotate the cone two times in 3. Push the cone till it stops.the same direction to spreadthe adhesive equally all aroundthe hole.◆Working methodWorking method◆Size◆Bond for Sealing Cone◆SizeFlat Surface 2329Dent Surface 2128.5Common to W5/16 and W3/8Remove the outer cap ofthe adhesive bond, andcut off about 5mm fromthe nozzle tip.Squeeze as much bond asshown in the figure.Push the cone before thebond drips.P u s h t h e c o n e t i l l i tstops.① ② ③ ④Type Quantity(pc/case)Package(kg/case) PackingDent 500 11.0 CaseFlat 500 12.0 CaseFeatures● Easy installation.● Long-lasting protection against wind and rain.(Adhesive) Curing daysCuring temperature Curing days20℃ 3~5 days５℃ 7~10 daysAdhesive forceWhen dried 257N/cm2（26.3kgf/cm2）Type Type and DimensionDent Surface Flat SurfaceCommon toW5/16 and W3/8● Do not use the product when concretesurface is wet.● Be sure to remove and clean aggregatesleft in the holes.● Avoid excessive tightening of form tiewhich cause deformation of plasticcones and holes.Cautions● Minimum usable temperature : 5℃● Be sure to cure after the installation,and do not give impact or vibration.● Check adhesive hardening before surfaceplasterwork.● Be sure to tighten the outer cap to preservethe bond after cutting the nozzle.5mmCutting positonfor ConeBond forConeProduct No. B10-0210Product No. B10-022038