BookTitleOkabe Product Catalog

Summary

Okabe Product Catalog

A　B　C　G　TemporaryConstructionConcreteRebar Work Formwork CivilEngineeringWhen beam width is700 mm or moreWhen beam width is 700 mm or lessType LType CP & Type CKType LBType LBWhen beam width is700 mm or less◆Size● The vertical load allowed for each product is up to the above-mentioned“ allowable load.”● Be sure to align the top end level of all products so that they will receive a uniform load.● Perform plumbing and correction of the product before arranging reinforcement.● Arrange the product vertically through the use of a stay bar, etc., to preventlateral movement as shown in Fig. 1.● Do Not use the product as scaffolding.● Precautions for arrangement- Space the products so that they will not receive a load that exceeds the allowable load.- Supporting the product is complicated where beam reinforcements are crossed oraround pillars. Therefore, be sure to examine load before arranging the product.- The top end of the leveling concrete on which the baseplate is installed shouldbe finished level.- Be sure to secure the baseplate with four anchor bolts.- Cure the leveling concrete until its compressive strength is enough to obtainthe predetermined anchor bolt strength.- Tighten the level adjusting bolt with a tightening torque of approximately2.94kN・cm (300kgf・cm). In case the bolt may be loosened due to vibration,etc., reinforce the bolt by welding.Cautions [Example of reinforcement of level load]Support rebarMain rebarLeveling concreteJoint bar anchorWeldingWeldingFooting Beam StandFig. 1 Example of reinforcementFeatures● Scaffolding for assembling rebars isnot necessary.● Height adjustment functionenables accuraterebar arrangement .● Hairpin rebar can be easilyfixed.Footing Beam Stand：LargeRebar assembling stand for footing beam workType L ? For beam? Type LB Type CP ? For pillar ? Type CKStopper bolt Stopper boltHairpin rebarHairpin rrebar　　Upper poleUpper poleLevel adjusting bolt Level adjusting boltBase plate Base plateLower pole Lower poleProduct No. C40-0010ModelAdjustmentheight H (mm)Pole Base plate sizeApplicable beam width(mm) per 1 UnitAllowable load kN(kgf)Weight(kg/pc)For beamL 507 400～ 640L30×30×3 L40×40×3□150×2.6700 or less3.92（400）2.0609 500～ 840 2.31015 800～1440 □200×2.6 3.31217 1150～1740□250×2.62.94（300） 4.41520 1450～2040 1.96（200） 4.8LB1520 1150～2130L40×40×3L50×50×43.92（400） 5.41625 1550～25402.94（300）6.82030 1880～3140 L40×40×5 10.0For pillarCP1625 1550～2540φ34×2.3φ42.7×2.3□250×3.2 800 or less 3.92（400）7.12030 1850～3170 8.1CK2035 2050～3590 □50×50×2.3 11.1Use D25 hairpin rebar (not included in the product configuration).115